PLA+ settings for the Creality Ender 5 S1
A starting profile for printing PLA+ on the Creality Ender 5 S1 (220 × 220 × 280 mm, open frame, direct drive). Tune from here with a temperature tower and a flow test.
| Setting | Starting value |
|---|---|
| Nozzle temperature | 205–225 °C (start 215) |
| Bed temperature | 55–65 °C (start 60) |
| Print speed | 100 mm/s |
| First layer speed | 20 mm/s |
| Layer height | 0.2 mm (0.12–0.28) |
| Retraction distance | 0.6 mm |
| Retraction speed | 30 mm/s |
| Part cooling fan | 100% |
| Enclosure | Open |
| Drying before use | 45 °C for 4 h |
This is a well-matched combination: the printer meets the material's requirements without compromise.
Why these values
The Creality Ender 5 S1 is a direct-drive machine, so retraction can stay short (around 0.6 mm). Its usable speed is around 200 mm/s, so the 100 mm/s above is within the comfortable range for this material.
Cooling is set to 100%: this material needs strong cooling for detail and overhangs.
Next steps
- Print a temperature tower across 205–225 °C and pick the cleanest band.
- Calibrate flow, then check the volumetric flow against your hotend.
- If something goes wrong, see the troubleshooting guide.
- Price the part with the cost calculator.